Exhaust gas treatment equipment instructions 1. During use, the concentration of acid and alkali in the absorbing solution should be checked in time. When the acid concentration is found to be too high, the absorbing solution should be replaced in time. 2. Clean and clean around the waste gas treatment equipment. 3. It is necessary to check whether the spray in the absorption tower is blocked. If it is blocked, it should be promptly sorted out or cleaned inside the tower. 4. The absorption liquid in the purification tower is increased through the addition tank. The liquid level is due to the level of the inlet blades. After the equipment is operated, some liquid will enter the circulation system, and the liquid will be increased again to make it level with the inlet. In the process of use, the use of absorption fluid should be investigated. When it is found that the consumption is excessive, it must be increased in time. The absorption fluid should be checked once every 8 hours, and it should be increased in time if it is lacking. 5. When the equipment is stopped, stop the blower for 1-2 minutes and then stop circulating the pump. When using, open the circulation pump for 2-3 minutes and then open the blower. [Organic exhaust gas treatment] [catalytic incineration] Sheet Metal Prototyping,Rapid Sheet Metal Prototyping,Rapid Sheet Metal Fabrication,Sheet Metal Rapid Prototype DONGGUAN TONJA INDUSTRIAL CO.LTD , https://www.tonjaism.com
Use exhaust gas treatment equipment need to pay attention to what the problem